Directed Electronics D800 Manual de Serviço Página 31

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 56
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 30
5-5
Switches #2,#3 and #4 on the control board #2860 are not applicable at
this time. Switch 1 only applies to Model FB-2 Football/Baseball
Scoreboard. The switch permits the choice of sports, either football or
baseball. To select baseball, Switch #1 should be “open.” It should be
closed for football. Set the switch before electrical power is applied to the
scoreboard. Select the appropriate operator’s console for either football or
baseball.
The control board #4290 is used for a variety of different models and
sports. If you have a model FB-1 scoreboard, set switch #3 to the open (1)
setting for football and the closed (0) setting for baseball. Contact the
Customer Service Department at Colorado Time Systems if you have ques-
tions.
All Colorado Time Systems’ scoreboards are designed to operate on
standing 115 VAC power. The AC power cord is shipped taped to the rear
of your scoreboard. Before applying power, consult Chapter 6 - Power
Requirements.
Installation of the speaker(s) involves plugging the speaker cable into the
control board as described in Step 3 on page 5-2 and then mounting the
speaker(s) on to the scoreboard module. Slide the speaker(s) into either
the top or the bottom channel of the scoreboard module or sponsor panel
module if applicable. The particular module selected varies depending on if
a sponsor panel is included and where the signage is installed.
Note: For Model BB-1 &BB-3, slide the speaker(s) into the bottom
channel of the BB-3 module and locate to the far right as you face
the module. The wrestling signage (“SCORE” “WT. CLASS”
“SCORE”) allocates the appropriate space.
Plug the public address microphone (PA) into the jack labeled “MICRO-
PHONE” located on the left side of your console. Plug the data cable
originating from the scoreboard (or from the wall box if a WB-1 was
ordered) into the jack located on the right side of your console, see Fig. 1,
on page 2-1.
For permanent installations, you may find it convenient to install a wall
box or junction box (Model WB-1) for your data cable connection. This
relieves the inconvenience of accessing the inside for your scoreboard each
time you want to disconnect the data cable. Use of the wall box option also
provides for easy storage of the operator’s console after use by unplugging
it from the wall box.
Control Board #2860
Control Board #4290
Model FB-1 Settings
Electrical Power Requirements
Speaker(s)
Operators (Keyboard) Console
Optional Wall Box (Model WB-1)
Vista de página 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 55 56

Comentários a estes Manuais

Sem comentários