Directed Electronics D800 Manual de Serviço descarregar pdf (Página 12)

Step 3: Repeat Step 2 for the other side of the module.

Step 4: If you purchased a Sponsor Panel, Model SP-A, the sponsor mod-

ule mounts above the top module as shown in Figure 11. Place the sponsor

module above the top module. Overhang one end of the sponsor module

and slide the flange extrusion into the top channel of the module. Repeat

for the other side.

This operation is similar to the “one-line module” mounting. Be sure to

place the scoreboard modules right side up to avoid mounting the modules

upside down.

Step 1: Place the bottom module on its back over a flat raised surface.

Note: The bottom module’s interconnect cable to the top module

and the serial number are located in the lower right side of the

module as you face the front of the unit.

Step 2: Align the portable leg’s bottom pre-drilled hole with the hole in

the bottom module’s endplate. Slide the legs from the portable stands

through the module’s formed endplates and slide the quick connect pins

through.

Step 3: Align the portable leg’s top pre-drilled hole with the hole in the

top module’s endplate and slide the quick connect pins through.

Step 4: Slide the black ABS plastic sign into the channel between the top

and bottom module.

Note: If you purchase a sponsor panel, Model SP-A, refer to Step 4

“One-Line Module.”

If you purchase the optional caddy with wheels, Module CAD-P, first

mount the portable legs to the scoreboard following the instructions pro-

vided. Then retrofit the caddy to the assembled scoreboard.

Figure 12: CAD-P Caddy

Two-Line Module

Optional Caddy

3-2

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 55 56

Sem comentários

Directed Electronics D800 Manual de Serviço Página 12