Directed Electronics D800 Manual de Serviço descarregar pdf (Página 18)

3-8

First determine the total number of modules you are installing:

a. a one-line scoreboard module only for a total of one module. (Example:

Model BA-1, Model FS-1, Model RT-2/4, Model BB-1).

b. a one-line scoreboard module with sponsor panel module for a total of

two modules. (Example: Model BA-1 with SP-E, Model FS-1 with SP-E,

Model RT-2/4 with SP-E, Model BB-1 with SP-E).

c. a two-line scoreboard only for a total of two modules. (Example: Model

BA-2, Model FB-1, Model FB-2, Model TN-1/2).

d. a two-line scoreboard with a sponsor panel for a total of three

modules. (Example: Model BA-2 with SP-D, Model FB-1 with SP-D,

Model FB-2 with SP-D, Model TN-1/2 with SP-B or SP-C).

Begin by mounting the top (uppermost) module, either the sponsor panel

module if applicable or the top line of the scoreboard module.

Measure, mark and drill mounting holes using dimensions provided. Make

sure holes are level by measuring up from the floor or down from the ceil-

ing, and/or by using a level.

Select the longer brackets (the brackets with pre-drilled holes) located in

your WM-4 or WM-5 kit. Slip the correct number of wall brackets into the

top channel on the rear of your scoreboard module (or sponsor panel mod-

ule) as Fig. 19 illustrates below. Position them as shown in Fig. 18 on the

previous page 3-7.

Figure 19

Slide the two small brackets (the brackets without holes), located in your

WM-4 or WM-5 kit, into the bottom channel of the same module. These

smaller brackets serve as leveling devices and do not require bolting to the

wall.

Raise the scoreboard module to mounting position as marked and drilled

in Step 1. Mount using the appropriate hardware.

Step 1

Step 2

Step 3

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 55 56

Sem comentários

Directed Electronics D800 Manual de Serviço Página 18