Directed Electronics D800 Manual de Serviço descarregar pdf (Página 19)

Leave a 9 1/2 inch separation between modules for the signage, and mount

the second module underneath the top module using the same procedure

as in Step 2.

Note: You may have to adjust the bottom module after sliding in

your signage to obtain a secure fit.

If a third module is applicable, leave a 9 1/2 inch separation between

modules for the signage, and mount the module as before.

Mount black ABS signage panel.

To mount the top sign panels, place the panel in the top outer edge score-

board groove. Position sign brackets at each of the pre-drilled hole posi-

tions on the sign panel. Secure the brackets in the top frame by twisting to

lock in place. Tilt the sign back to engage the bracket fingers in the sign

panel holes. Thread wire nuts onto the top fingers protruding from the

side panel, see Fig. 20 below.

Figure 20

Or if the signage panel mounts between two modules, slide the signage

into the channel between the top and bottom modules.

For owners of Model BB-1 and BB-3, a third signage for wrestling

(“SCORE” “WT. CLASS” “SCORE”) mounts to the bottom of the BB-3

module.

3-9

Step 3

Step 4

Step 5

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 55 56

Sem comentários

Directed Electronics D800 Manual de Serviço Página 19