Directed Electronics 381 Series Guia de Instalação descarregar pdf (Página 6)

H1/3 WHITE/BLUE

(-) Channel Three output:This wire provides a 200mA output whenever the transmitter button(s)

controlling Channel Three is pressed. In the default setting this signal will continue as long as that transmission is

received (called validity). The Channel Three output can also be programmed to provide the following types of out-

puts (see system features learn routine):

Latched: Output that turns on the first time the button is pressed and turns off the next time the same but-

ton is pressed.

Latched, reset with ignition: Output that turns on the first time the button is pressed and turns off the next

time the same button is pressed. This output will cease when the ignition is turned on and then

off.

Timed: Output that turns on for a selectable amount of time (30/60/90 seconds) and stays on until

the time runs out or the transmitter button is pressed again.

IMPORTANT! Never use this wire to drive anything but a relay or a low-current input! This transistorized out-

put can only supply 200 mA, and connecting directly to a solenoid, motor, or other high-current device will

cause the module to fail.

H1/4 BLACK/WHITE

high current output from on-board domelight supervision relay: Connect this wire directly to

the domelight circuit in the vehicle. The on-board relay will drive circuits up to 20 amperes. The polarity of this out-

put is determined by the connection of the input wire (H2/B) in the Door Lock Harness.

NOTE: If the input wire (H2/B) is not connected, there will be no output on this wire.

H1/5 GREEN

(-) door trigger input: Most vehicles use negative door trigger circuits. Connect the GREEN wire to a

wire which shows ground when any door is opened. In vehicles with factory delays on the domelight circuit, there

is usually a wire that is unaffected by the delay circuitry.

H1/6 BLUE

(-) instant trigger: This input will respond to a negative input with an instant trigger. It is ideal for hood

and trunk pins and will report on zone one. It can also be used with 506T Glass Breakage Sensor, as well as other

DEI

single stage sensors.

H1/7 VIOLET

(+) door trigger input: This type of dome circuit is used in many Ford products. Connect the VIOLET

wire to a wire that shows +12V when any door is opened, and ground when the door is closed.

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Sem comentários

Directed Electronics 381 Series Guia de Instalação Página 6