Directed Electronics 381 Series Guia de Instalação descarregar pdf (Página 26)

When using the diagnostic functions, use the Table of Zones to see which input has triggered the system. It is also

helpful in deciding which input to use when connecting optional sensors and switches.

NOTE: The Warn Away

triggers report to the LED when the system is disarmed. However, the siren does

not indicate a Warn Away

trigger.

Long-term e

vent history

The system stores the last two full triggers in memory. These are not erasable. Each time the unit sees a full trig-

ger, the older of the two triggers in memory will be replaced by the new trigger. To access long-term event history:

1. Press and hold the Valet

/Program switch.

2. Turn on the ignition, while continuing to hold the Valet/Program switch.

3. Release the Valet/Program switch.

4. Press and release the Valet/Program switch within 5 seconds.

The LED will flash in groups for one minute, or until the ignition is turned off, to indicate the last

two zones that triggered the unit.

NOTE: The Warn Away

triggers are not stored to memory.

TABLE OF ZONES

Zone Trigger Type Wire/Input description

One Instant BLUE wire (H1/6): Connect to optional hood/trunk

inputs

Two Multiplex-Instant BLUE and GREEN wires of plug-in shock sensor.

Sensor 1 Inputs longer than 0.8 second will trigger this zone.

Three Programmable GREEN (H1/5) or VIOLET (H1/7): This input is

programmable to be an instant or progressive trigger.

Four Multiplex-Instant GREEN/BROWN wire (H3/1): Use for optional

Sensor 2 sensors. Inputs longer than 0.8 second will trigger

this zone.

Five Multiplex-Warn Away

BLUE and GREEN wires of plug-in shock sensor.

Sensor 1 Inputs shorter than 0.8 second will trigger this zone.

Six Multiplex-Warn Away

GREEN/BROWN wire (H3/1):For optional Warn Away

Sensor 2 sensors. inputs shorter than 0.8 second will trigger

this zone.

Seven Zone 7 is reported on power up and panic.

Eight Progressive YELLOW wire (H1/9): If the ignition is turned on while

the system is armed, the siren will chirp ten times and

then the full triggered sequence will begin.

1 2 ... 21 22 23 24 25 26 27 28

Sem comentários

Directed Electronics 381 Series Guia de Instalação Página 26