Directed Electronics 3100 Instruções de Operação descarregar pdf (Página 15)

3 Remove approx. 10 cm (4 in) of the cable mantle, strip

approx. 1 cm (0.4 in) insulation from the ends of the

individual wires

4 Insert the cable into the sensor through the cable entry

5 Lift the open ing levers of the terminals with a screwdriver

(see following illustration)

6 Insert the wire ends into the open terminals according to

the wiring plan

7 Press down the opening levers of the terminals, you will

hear the terminal spring closing

8 Check the hold of the wires in the terminals by lightly

pulling on them

9 Tighten the compression nut of the cable entry, the seal

ring must completely encircle the cable

10 Screw the housing cover back on

The electrical connection is ﬁnished.

Fig. 7: Connection steps 5 and 6

5.3 Wiring plans, single chamber housing

The following illustrations apply to the non-Ex as well as to the

EEx d version .

OPTISWITCH 3100 C - with two-wire output 15

Connecting to power supply

29955-EN-060112

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Sem comentários

Directed Electronics 3100 Instruções de Operação Página 15