Directed Electronics Valet 561T Guia de Instalação descarregar pdf (Página 12)

1122

pprriimmaarryy hhaarrnneessss ((HH11)),, 99--ppiinn ccoonnnneeccttoorr

This wire sends a negative pulse every time the remote start is activated or the doors are unlocked. This can be

used to pulse the disarm wire of the vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to

the disarm wire as shown in the following diagrams.

RReellaayy ffoorr NNeeggaattiivvee ((--)) DDiissaarrmm WWiirree RReellaayy ffoorr PPoossiittiivvee ((++)) DDiissaarrmm WWiirree

This wire sends a negative pulse every time the remote start shuts down or the doors are locked. This can be

used to pulse the arm wire of the vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to the

arm wire

AAss aa ssttaanndd--aalloonnee ssyysstteemm::

The H1/3 YELLOW wire should not be connected to anything.

ss aann aadddd--oonn ccaarr ssttaarrtteerr::

If connected, disconnect the ignition/accessory input of the remote controlled secu-

rity or keyless entry system. Connect the H1/3 YELLOW ignition output to the ignition/accessory input of the

remote controlled security or keyless entry system. The wire will prevent the host system from sensing that the

ignition is on during remote start operation.

This input comes from the factory set to 2 activation pulses. This means that it is necessary to have 2 consecu-

tive ground pulses on the white/blue wire for the remote start to activate or to deactivate. The same holds true

for the remote control activation when set to a two pulse setting it is necessary to press the button twice

for the remote start to activate or deactivate.

HH11//44 WWHHIITTEE//BBLLUUEE rreemmoottee ssttaarrtt ((--)) aaccttiivvaattiioonn iinnppuutt

HH11//33 YYEELLLLOOWW ((++)) iiggnniittiioonn oouuttppuutt ttoo RRFF ssyysstteemm

HH11//22 GGRREEEENN//WWHHIITTEE ffaaccttoorryy rreeaarrmm

HH11//11 LLIIGGHHTT GGRREEEENN//BBLLAACCKK ((--)) ffaaccttoorryy aallaarrmm ddiissaarrmm

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 38 39

Sem comentários

Directed Electronics Valet 561T Guia de Instalação Página 12