Directed Electronics 200 Guia de Instalação

Model 200Installation Guide© 2001 Directed Electronics, Inc. Vista, CA N122 3-01Rev. B 1.0®

10 © 2001 Directed Electronics, Inc. Vista, CAprimary harness wire connection guideThis wire can be used to protect a part of the vehicle where a trig

© 2001 Directed Electronics, Inc. Vista, CA 11Connect this wire to one of the mercury tilt switches’ wires. Connect the other tilt switch wire to batt

12 © 2001 Directed Electronics, Inc. Vista, CAConnect this wire to an ignition wire as described in the Finding the Wires You Need section of this man

© 2001 Directed Electronics, Inc. Vista, CA 13When the system receives the code controlling Channel 2 for longer than 1.5 seconds, the red/white wire

14 © 2001 Directed Electronics, Inc. Vista, CAmaking siren connectionsInstructions for connecting the siren wires are described below.Connect this wir

© 2001 Directed Electronics, Inc. Vista, CA 15plug-in LED and valet/program switchThese plug into the module. The Status LED plugs into the white two-

16 © 2001 Directed Electronics, Inc. Vista, CAtransmitter/receiver learn routineThe system comes with two transmitters that must be “taught” to the re

© 2001 Directed Electronics, Inc. Vista, CA 17system features learn routineThe System Features Learn Routine™dictates how the unit operates. It is pos

18 © 2001 Directed Electronics, Inc. Vista, CATo exit the System Features Learn Routine, do one of the following: Turn the ignition on. No activity

© 2001 Directed Electronics, Inc. Vista, CA 196 CHANNEL 3 INSTANT/LATCHED/LATCHED RESET WITH IGNITION/30-SECOND TIMED/60-SECOND TIMED/90-SECOND TIMED

2 © 2001 Directed Electronics, Inc. Vista, CAtable of contentsBitwriter™, Code Hopping™, DEI®, Doubleguard®, ESP™, FailSafe®, Ghost Switch™, LearnRout

20 © 2001 Directed Electronics, Inc. Vista, CAnuisance prevention circuitryNuisance Prevention®Circuitry (NPC®) is designed to prevent repeating trigg

© 2001 Directed Electronics, Inc. Vista, CA 21table of zonesWhen using the Diagnostic functions, use the Table of Zones to see which input has trigger

22 © 2001 Directed Electronics, Inc. Vista, CAThe siren sounds weak or garbled: Check all the grounding points, including the siren ground and alarm

© 2001 Directed Electronics, Inc. Vista, CA 23notes

24 © 2001 Directed Electronics, Inc. Vista, CA

© 2001 Directed Electronics, Inc. Vista, CA 3what is includedShock SensorSensitivityAdjustmentH1 PrimaryHarness Port(14-Pin Connector) White LED Port(

4 © 2001 Directed Electronics, Inc. Vista, CAinstallation points to rememberThis system has many unique features, some of which require unique testing

© 2001 Directed Electronics, Inc. Vista, CA 5deciding on component locationsSome things to remember when mounting the siren: Mount the siren with scr

6 © 2001 Directed Electronics, Inc. Vista, CAfinding the wires you needNow that you have decided where each component will be located, you’re going to

© 2001 Directed Electronics, Inc. Vista, CA 74. Turn the ignition key switch to the run position. If your meter reads (+)12V, go to the next step. If

8 © 2001 Directed Electronics, Inc. Vista, CAmaking your wiring connectionsBefore making your connections, plan how your wires will be routed. For ins

© 2001 Directed Electronics, Inc. Vista, CA 9primary harness (H1), 14-pin connector___________________________________________________________________