Directed Electronics VS102 Especificações descarregar pdf (Página 50)

Peripheral Interfacing Options with Vocollect Voice Appliances Page 42

1-Dec-2010 Version 4.0

Peripheral operation – Intermec SF-51 Flashlight Scanner & Talkman T5 Series Page 42

Rev 1.0/jjd

• Code 39 and 128 Barcode test

• Rapid scanning (4/sec and 40/10 sec) - does not seem to process all data

• Testing with other peripherals (SRX, BT printer etc)

Voice Console Test Scenarios:

• Pairing through Voice Console

• Clearing from Voice Console

• Pairing with multiple BT devices (Printer, SRX etc)

• New pairing clears old pairing

• Pair two Peripheral devices with same Talkman device

Failure test scenarios:

• Battery pull of Talkman device when paired and running through scanning task

• Pull Talkman device battery in the middle of pairing

• Walk out of range of Wi-Fi and pull Talkman battery

• Walk out of BT range of paired devices and check for scanning operation and its

communication with Voiceclient on T5.

• Walk out of range of Talkman device and power down Peripheral (scanner ) device

• Attempt to clear pairing from Console when Peripheral device is out of BT range from

Talkman device.

Stress Scenarios:

• Pair Bluetooth scanner, printer, and SRX with Talkman device via Console

• Pair Bluetooth scanner, printer, SRX, then cradle Talkman device

• Pair Bluetooth scanner, printer, SRX, then pull/replace battery on Talkman device

• Pair Bluetooth scanner, printer, SRX, then power off/on Talkman device

• Attempt to pair Talkman device with Scanner while device is cradled

• Attempt to pair Scanner with device while scanner is being charged

• Attempt to pair peripherals without/with required parameters

Notes:

A default Bluetooth PIN of 0000 is required to be used.

The scanner may take 1-2 minutes to pair with the Talkman as either acceptor or initiator.

The rapid scanning test seemed to indicate that the scanner was not sending data rapidly, perhaps

discarding some scans.

The scanner may sometimes disconnect, however it automatically will reconnect.

The Bluetooth “paired with” address is not always correctly displayed in VoiceConsole.

During initial pairing, with the scanner as an initiator, the scanner should be close to the T5 to

successfully pair.

The scanner range of connection seems to be less when it is the initiator and more when it is the

acceptor.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 56

Sem comentários

Directed Electronics VS102 Especificações Página 50