Directed Electronics VS102 Especificações descarregar pdf (Página 34)

Peripheral Interfacing Options with Vocollect Voice Appliances Page 26

1-Dec-2010 Version 4.0

Peripheral operation - LXE 8652 Ring Scanner & Talkman T5 Series Page 26

Rev 1.0/jjd

Overview

The LXE 8652 ring scanner may be successfully used with all Talkman T5 Series (T5, T5m)

terminals. It provides a convenient hands-free way to capture bar codes including 2D codes.

Vocollect can provide initial set-up support for this scanner and answer general questions about

scanning and working with Talkman. Detailed questions about scanner operation, configuration and

options can be answered by the scanner vendor or agent from which the scanner was purchased.

During scanner operator it is possible for a number of reasons for the scanner to disconnect from the

Talkman. Some examples of this include:

 The operator takes the scanner out of radio range of the Talkman

 The Talkman is powered off

 Excess radio frequency activity momentarily disrupts the communication link

When the scanner is setup so that Talkman initiates connection, Talkman will typically

automatically recover the connection with no intervention. If the scanner initiates the connection, it

typically will require one button press to activate and recover followed by a second press to actually

perform a useful scan.

It is strongly recommended to fully initialize the scanner to a known condition by the procedure in

section 1.1 before attempting to use the scanner. Note that the scanner only acknowledges the first

“reset” barcode with an audible tone. Subsequence barcodes on this page are silently acknowledged

as successful when the scan beam extinguishes. (The scanner should be approximately 1’ (foot) from

the page with the centered red cross almost filling the barcode to be scanned for the scans to be

successful on the set-up page.)

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 55 56

Sem comentários

Directed Electronics VS102 Especificações Página 34