Directed Electronics AutoCommand 25622 Guia de Instalação descarregar pdf (Página 21)

Many Nissan and late-model Chrysler vehicles have two starter

wires. A relay and/or resistor (not provided) is required to hook up

the additional starter wire. Refer to the diagram below.

Once you locate the starter wire, cut the wire in half (check the

web information before cutting) and try to start the vehicle. If

the vehicle does not start, the correct wire has been identified.

Reconnect both ends of the starter wire while soldering the thick

YELLOW wire of the heavy guage wires to it and wrap the connec-

tion with electrical tape.

note! Always check the Web site information

on your vehicle for warnings regarding the

starter wire and check engine lights. Some

vehicles will trip a check engine light if the

starter wire is cut.

87A

+12 VDC CONSTANT (FUSED 20A)

GROUND

TO 2

STARTER

YELLOW (+) OUTPUT

TO STARTER

STARTER RELAY

(NOT PROVIDED)

87A

+12 VDC CONSTANT (FUSED 20A)

GROUND

TO STARTER

STARTER RELAY

(NOT PROVIDED)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 56 57

Sem comentários

Directed Electronics AutoCommand 25622 Guia de Instalação Página 21