Directed-electronics Ready Remote Manual do Utilizador descarregar pdf (Página 44)

step 7

Engine monitoring (voltage—default setting)—optional

During remote start the system will need to know if the engine

is running. The module does this by monitoring the voltage of

the vehicle’s electrical system (or the tachometer-see next topic).

When the vehicle is not running the electrical system is approx-

imately 12 volts. The system detects the engine running when

the voltage increases by 1 volt above the resting battery voltage.

The remote start system monitors the increase to prevent the

starter from cranking when the vehicle is already running.

If the remote start system sees the voltage drop by 1/2V the

system assumes the engine is not running and will shut down the

Ignition/Accessory circuit.

➜

H2/2

H2/3

H2/4

H2/5

H2/6

H2/7

LOCK

RELAY

UNLOCK

RELAY

#87

#87A

#30

#87

#87A

#30

TO CHASSIS

GROUND

BCM

15A

GREEN/BLACK LOCK #30 COMMON (OUTPUT)

WHITE/BLACK NOT USED

VIOLET/BLACK LOCK #87A NORMALLY OPEN (INPUT)

BROWN/BLACK NOT USED

BLUE/BLACK UNLOCK #30 COMMON (OUTPUT)

VIOLET UNLOCK #87 NORMALLY OPEN (INPUT)

VIOLET & VIOLET/BLACK ARE COMMON AT FUSE HOLDER

LOCK RESISTOR

(IF REQUIRED)

UNLOCK RESISTOR

(IF REQUIRED)

DOOR LOCK SWITCH/

KEY CYLINDER

UNLOCK

CHASSIS

GROUND

LOCK

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 69 70

Comentários a estes Manuais

Sem comentários

Directed-electronics Ready Remote Manual do Utilizador Página 44

Comentários a estes Manuais

Manuais e produtos relacionados com Controlo remoto Directed-electronics Ready Remote