Directed Electronics Concept 550 Guia de Instalação descarregar pdf (Página 12)

www.directed.com

NNOOTTEE::

In order for the system to bypass the immobilizer with the jumper in place, the

unit must have ground on the 18-pin harness.

door lock harness wire connection guide

___

IIMMPPOORRTTAANNTT!!

The door lock outputs are low current and should not be attached direct-

ly to any high-current device; they are only to be used to activate relays.

type A: positive (+) 12-volt pulse

The system can control Type A door locks directly, with no additional parts. The switch

will have three wires on it; one will test (+)12 volt constantly. The others will alternate-

ly pulse (+)12 volt when the switch is pressed to the lock or unlock position.

If you cannot get to the switch, and you find a set of wires that pulse (+)12 volt alter-

nately on lock and unlock, make sure that it is not a Type C direct-wire system.

Cut the wire that pulses (+)12 volt on lock, and then operate the switch to unlock.

If all doors unlock, the vehicle uses type A system.

If you lose all door lock operation in both directions, you are operating the mas-

ter switch in a Type C system.

If you lose all door lock operation of one or more, but not all motors, and other

doors still work, you have cut a wire leading directly to one or more motors. You

must instead find the actual wires leading to the switch.

IIMMPPOORRTTAANNTT!!

Remember that these wires' functions reverse between Type A and Type B.

BLUE (-) Unlock, (+) Lock Output

EMPTY (+) 12V Protected, Low Current for 451M

GREEN (-) Lock, (+) Unlock Output

H3/1

H3/2

H3/3

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Sem comentários

Directed Electronics Concept 550 Guia de Instalação Página 12