Directed Electronics Concept 550 Guia de Instalação descarregar pdf (Página 11)

immobilizer harness wire connection guide

immobilizer harness wiring

Locate the ignition and starter wires using a multimeter. Cut the appropriate wire and

attach the key side and car side wires to the corresponding wires on the four-pin

immobilizer harness.

NNOOTTEE::

The diagram below shows the module side of the connector (looking into the

female pins).

ultrasecure immobilizer

The UltraSecure immobilizer circuit in this G5 system is a unique new design that incor-

porates the immobilizer security of Clifford without the possibility of failure due to power

loss that could potentially strand the user. The level of security can be set by leaving in

or removing the jumper located next to the immobilizer wires exiting the module.

immobilizer jumper setting

jumper in setting

When the jumper is in, the ignition and starter signal will bypass the UltraSecure

immobilizer circuitry and allow the vehicle start and run, even if power has not been

restored to the module.

jumper out setting

When the jumper is out, the UltraSecure immobilizer circuitry prevents the ignition

and starter signal from passing and keeps the vehicle immobilized until power has

been restored to the module.

H3/4 Ignition Car Side

H3/3 Ignition Key Side

H3/2 Starter Key Side

H3/1 Starter Side

CUT

Starter

Ignition

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Sem comentários

Directed Electronics Concept 550 Guia de Instalação Página 11