Directed Electronics Automate 210D Guia de Instalação descarregar pdf (Página 44)

Are the door inputs connected? Is the H1/6 blue wire connected

to the door trigger wire in the vehicle? Either the H1/5 green or

the H1/7 violet should be used instead. (See Primary Harness

Wire Connection Guide section of this guide.)

➤

DDoooorr iinnppuutt ddooeess nnoott rreessppoonndd wwiitthh tthhee pprrooggrreessssiivvee ttrriiggggeerr,,

bbuutt wwiitthh iimmmmeeddiiaattee ffuullll aallaarrmm::

Does the Status LED indicate that the trigger was caused by the

shock sensor? (See Table of Zones section of this guide.) The

shock sensor, if set to extreme sensitivity, may be detecting the

door unlatching before the door switch sends its signal.

Reducing the sensitivity can solve this problem.

➤

TThhee VVaalleett

®®

//PPrrooggrraamm sswwiittcchh ddooeessnn''tt wwoorrkk..

Is it plugged into the correct socket? (See Plug-In LED and

Valet

/Program/Program Switch section of this guide.)

➤

SSttaattuuss LLEEDD ddooeessnn''tt wwoorrkk..

Is the LED plugged into the correct socket? (See Plug-In LED

and Valet

/Program Switch section of this guide.)

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 54 55

Sem comentários

Directed Electronics Automate 210D Guia de Instalação Página 44