Directed Electronics 671XP Guia de Instalação descarregar pdf (Página 6)

2004

Directed Electronics, Inc.

is pressed. This output can be programmed to provide the following types of output (see

System

Features Learn Routine

section of this guide):

➤➤

vvaalliiddiittyy

output will send a signal as long as the transmission is received.

➤➤

llaattcchheedd

output will send a signal continuously when the Channel 3 button(s) is pressed and

released. The signal will continue until channel three is pressed again.

➤➤

llaattcchheedd//rreesseett wwiitthh iiggnniittiioonn

output works similar to the latched output, but will also reset

(output will stop) when the ignition is turned on and then off.

➤➤

3300 sseeccoonndd ttiimmeedd

output will send a signal for 30 seconds when channel three is pressed. This

output can be shut off during the 30-second period by pressing Channel 3 again.

➤➤

This output can also be programmed to provide a

sseeccoonndd uunnlloocckk ppuullssee

when the unlock button

is pressed a second time after disarming the system. This can be used to unlock the passenger

doors when installing progressive door locks.

H1/4 BLACK/WHITE (-) 200 mA domelight supervision output

Connect the H1/4 wire to the optional domelight supervision relay as shown in the following

diagram:

IMPORTANT! This output is only intended to drive a relay. It cannot be connected

directly to the domelight circuit, as the output cannot support the current draw of one

or more bulbs.

IMPORTANT! Never use this wire to drive anything but a relay or a low-current input!

This transistorized output can only supply 200 mA, and connecting directly to a

solenoid, motor, or other high-current device will cause the module to fail.

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Sem comentários

Directed Electronics 671XP Guia de Instalação Página 6