Directed Electronics 671XP Guia de Instalação descarregar pdf (Página 13)

2004

Directed Electronics, Inc.

Programming Jumper

Light Flash Jumper

This jumper is used to determine the light flash output. In the (+) position, the on-board relay is

enabled and the unit will output (+)12V on the WHITE wire, H1/2. In the (-) position, the on-

board relay is disabled. The WHITE wire, H1/2, will supply a 200 mA (-) output suitable for

driving factory parking light relays.

NOTE: For parking light circuits that draw 10 amps or more, the jumper must be switched to a (-)

light flash output. P/N 8617 or a standard automotive SPDT relay must be used on the H1/2 light

flash output harness wire.

IMPORTANT! DO NOT connect the H1/2 light flash wire to a negative vehicle light

flash wire before changing the programming jumper to the negative polarity position or

damage to vehicle light circuit may occur.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Sem comentários

Directed Electronics 671XP Guia de Instalação Página 13