Directed Electronics 554R Guia de Instalação descarregar pdf (Página 33)

4. In gasoline vehicles, the engine will start four seconds after

the parking lights flash. In diesel vehicles, the engine will

start when the WAIT-TO-START indicator on the vehicle's

dash goes out.

5. Once the vehicle has started, it will run for the pre-program-

med period of time (either 12, 24, or 60 minutes - see

Programming Options section of this guide) or until a shut-

down input is triggered. When using the Directed Bitwriter,

the run time can be programmed from 1-60 minutes.

When you are ready to drive the vehicle:

1. Insert the ignition key and turn

it to the ON (not the START)

position.

2. Press the brake pedal.

To shut down the remote start and turn off the engine:

While the vehicle is running during remote start operation, the

system will monitor the vehicle and will automatically shut

down the engine if the system receives any of the following shut-

down inputs:

➤ The brake pedal is pressed.

note: If the brake pedal is pressed before the key is in the

ON position, the engine will shut down.

important! It is unsafe to operate a vehicle’s motor in a

garage or other closed off area. Breathing the exhaust

from the vehicle is hazardous to your health. Never acti-

vate the remote start in an enclosed space.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 52 53

Sem comentários

Directed Electronics 554R Guia de Instalação Página 33