Directed-electronics 6000 Manual do Utilizador descarregar pdf (Página 17)

1999 Directed Electronics, Inc.

The operations described in this section refer to transmitter

buttons. Remember, the buttons used in all the instructions in this

guide correspond to a Standard Configuration transmitter. This

may not be how your transmitter is set up.

1. Open any vehicle door.

2. Press .

3. Press .

4. Press again.

The status LED will light solidly if you are entering Valet Mode, and

it will go out if you are exiting Valet Mode.

Your system has DEI

’s Nuisance Prevention

Circuitry (NPC

™

). It

prevents annoying repetitive trigger sequences due to faulty door

pin switches or environmental conditions such as thunder, jack-

hammers, airport noise, etc. Here’s how it works:

The alarm triggers three times. Each time, the same sensor or

switch is triggering the alarm. The three triggers are within 60

minutes of each other. NPC

™

will interpret this pattern of triggers

as false alarms. After the third trigger, NPC

™

ignores, or bypasses,

that sensor or switch (along with any other sensors or switches

sharing the same zone) for 60 minutes.

Nuisance Prevention

Circuitry

Remote Valet

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

Sem comentários

Directed-electronics 6000 Manual do Utilizador Página 17