Directed-electronics 259D Manual do Utilizador descarregar pdf (Página 13)

step 1

Ground Wire

The BLACK wire on the main 8-pin harness is ground. This

wire should be connected to a clean, paint-free area of metal in

the drivers kick panel area. First strip back a ¾-inch section of

the insulation off the BLACK wire and crimp a ring terminal

(not provided) to that wire. Locate a clean, paint-free metal

surface in the drivers kick panel. Using a self-tapping screw, drill

the screw with the ring terminal to the metal area. Once screwed

down, pull on the wire to ensure a good connection.

SELF-TAPPING

BOLT OR SCREW

RING

CONNECTOR

GROUND

WIRE

NOTE: REMOVE ANY PAINT

BELOW RING CONNECTOR

DIA-591

note: More problems are attributed to poor ground con-

nections than any other cause. Take extra care to ensure

the ground is clean and secure.

➜

warning! Verify that the vehicle is set to

park and that the parking brake is set

before beginning installation.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 48 49

Sem comentários

Directed-electronics 259D Manual do Utilizador Página 13