Directed Electronics D2400 Instruções de Operação descarregar pdf (Página 10)

6. Start-up and Maintenance

6.4 Lubrication

Prior to every putting into operation all lubricating points of the lathe must be lubricated with grease

for roller bearings of commercial quality.

Both guiding bars have to be greased before every putting into operation. The two dovetail guides

of the cross support, the threaded spindles accessible from below, the feed shaft as well as the

tailstock sleeve have to be greased with lubricating oil every 100 service hours.

When greasing make sure to put the slide of the cross support to its hindmost position while moving

the tailstock sleeve to its foremost position. The tailstock spindle is to be greased via the hollow

bore in the sleeve.

app

y grease pr

or to

every putting into operation

6.5 Initial cleaning of the machine

Prior to the initial operation all bare parts have to be cleaned by applying petroleum or benzine,

because these parts were covered with antirust oil before leaving the factory.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 38 39

Sem comentários

Directed Electronics D2400 Instruções de Operação Página 10