Directed Electronics MAXX3 Guia de Instalação descarregar pdf (Página 11)

1. Inspect all alarm wiring. Make sure all wires are connected.

2. Install the 5 amp fuse in the BLACK wire with RED tag fuse assembly.

3. Install the 20 amp fuse in the BLACK wire with WHITE tag fuse assembly (if the vehicle indicator lights are

positive).

NOTE: Remove tags from wires after connection.

Final Wiring Connections

System Status/Diagnostic Charts

LED Status

Off System is disarmed.

On In Valet mode.

Slow Flash Passive Immobilised only.

Double Flash System is armed and Immobilised.

Triple Flash More than three consecutive incorrect Valet

codes have been entered (system ignores

Valet switch for two minutes).

Flashing in Cycles See "Specific Zone Intrusion Identification"

chart below.

Rapid Flash Passive arming countdown.

If the alarm has been triggered, the siren will chirp three times upon remote disarm. Turn the ignition ON and

count the LED flashes. Each flash cycle is repeated two more times giving three cycles in total.

LED Zone Input Description

Three Flashes Optional Sensor 2 Dual Zone 4-pin

Four Flashes Door Trigger Input (-) P2 Pin 8 GREEN

Five Flashes Boot/Bonnet Trigger P2 Pin 2 BLUE/WHITE or Pin 7 BLUE

Six Flashes Normally Closed Trigger Input (-) P2 Pin 4 BLACK/WHITE

Seven Flashes Ultrasonic Sensor P1 Pin7/8/9 Ultrasonic sensors

Eight Flashes Ignition Trigger P2 Pin 3 BLACK with ORANGE Tab

Specific Zone Intrusion Identification

LED System Status Indicator

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Sem comentários

Directed Electronics MAXX3 Guia de Instalação Página 11