Directed Electronics MAXX3 Guia de Instalação

© 2002 Directed Electronics, Inc. Vista, CA N840003 4-02Maxx3Installation Guide

Pin Number Wire Colour Description1 BLACK with WHITE TAG No. 1 Immobiliser Circuit No.12 BLACK with WHITE TAG No. 2 Immobiliser Circuit No.13 BLACK

1. Inspect all alarm wiring. Make sure all wires are connected.2. Install the 5 amp fuse in the BLACK wire with RED tag fuse assembly.3. Install the 2

© 2002 Directed Electronics, Inc.12When you press the remote buttons, the system will respond with chirps and indicator light flashes. This is toindic

© 2002 Directed Electronics, Inc.13

© 2002 Directed Electronics, Inc.14

© 2002 Directed Electronics, Inc.15

© 2002 Directed Electronics, Inc.16

© 2002 Directed Electronics, Inc.17

© 2002 Directed Electronics, Inc.18Personal Identification Number (PIN)Each system has an individual four-digit PIN. In order to access Valet mode or

© 2002 Directed Electronics, Inc.19Programmable FeaturesAll system features and remote control features are accomplished by entering your Personal Ide

Table of ContentsImportant Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

© 2002 Directed Electronics, Inc.20Feature Factory Setting No. of Chirps Secondary ActionPassive Arming ON 2 Press button. The siren will chirp once

© 2002 Directed Electronics, Inc.21Feature Factory Setting No. of Chirps Secondary ActionArm/Disarm/Panic Button Channel 1 20 Press any remote button(

© 2002 Directed Electronics, Inc.22Final Testing Checklist In the "Recommended Procedures" section on page 3, you removed the interior ligh

© 2002 Directed Electronics, Inc.23Wiring DiagramsNOTE: The current draw for the entire security system when in the armed state is 20mA. Powersupply v

© 2002 Directed Electronics, Inc.24NOTE: Remove all tags from wires after connection.

Important InformationIMPORTANT! The Avital Maxx3system is designed to be installed in any petrol powered vehicle witha 12 volt battery.One Avital Maxx

© 2002 Directed Electronics, Inc.4Installation ProceduresCAUTION: The Avital Maxx3control unit must be installed inside the vehicle. Under no circum-s

© 2002 Directed Electronics, Inc.51. Choose a location at the top of the A-pillar on both driver and passenger sides.2. Mount the sensors using the sc

© 2002 Directed Electronics, Inc.6Pin Connector ChartsPin Number Wire Colour Description1 WHITE/BLUE Channel 4 Accessory (-) Pulsed or Timed Output2

© 2002 Directed Electronics, Inc.71. Press the button once and the driver’s door only will unlock.2. Press the button again within three seconds and

© 2002 Directed Electronics, Inc.8Pin Number Wire Colour Description1 NOT USED Not Used2 BLUE/WHITE Boot Trigger (-) Input3 BLACK with ORANGE TAG Ign

© 2002 Directed Electronics, Inc.9GREY Prewired to Valet Switch (P2/5)The GREY wire is switched to ground whenever the valet switch is pressed.ORANGE