Directed Electronics 1500ESP Guia de Instalação descarregar pdf (Página 9)

primary harness (H1) wire connection guide

This wire supplies a (-)500 mA ground as long as the system is armed. This output ceases as soon as the system

is disarmed. The orange wire is pre-wired to control the DEI

8618 Starter Kill Relay.

IMPORTANT! Never interrupt any wire other than the starter wire.

NOTE: If connecting the orange wire to control another module, such as a DEI

529T or 530T

window controller, a 1 amp diode (type 1N4004) will be required. Insert the diode as shown below.

As shipped, this wire should be connected to the (+) parking light wire. If the light flash polarity jumper under

the sliding door is moved to the opposite position (see Internal Programming Jumper section of this guide), this

wire supplies a (-) 200 mA output. This is suitable for driving (-) light control wires in Toyota, Lexus, BMW, some

Mitsubishi, some Mazda, and other model cars.

(+) Positive Light Flash Output

H1/2 WHITE (+/-) selectable light flash output

H1/1 ORANGE (-) ground-when-armed output

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 51 52

Sem comentários

Directed Electronics 1500ESP Guia de Instalação Página 9